d5dedd4507
according to Ingo, change set_affinity() in irq_chip should return int, because that way we can handle failure cases in a much cleaner way, in the genirq layer. v2: fix two typos [ Impact: extend API ] Signed-off-by: Yinghai Lu <yinghai@kernel.org> Cc: Andrew Morton <akpm@linux-foundation.org> Cc: Suresh Siddha <suresh.b.siddha@intel.com> Cc: "Eric W. Biederman" <ebiederm@xmission.com> Cc: Rusty Russell <rusty@rustcorp.com.au> Cc: linux-arch@vger.kernel.org LKML-Reference: <49F654E9.4070809@kernel.org> Signed-off-by: Ingo Molnar <mingo@elte.hu>
163 lines
4.1 KiB
C
163 lines
4.1 KiB
C
/*
|
|
* Malta Platform-specific hooks for SMP operation
|
|
*/
|
|
#include <linux/irq.h>
|
|
#include <linux/init.h>
|
|
|
|
#include <asm/mipsregs.h>
|
|
#include <asm/mipsmtregs.h>
|
|
#include <asm/smtc.h>
|
|
#include <asm/smtc_ipi.h>
|
|
|
|
/* VPE/SMP Prototype implements platform interfaces directly */
|
|
|
|
/*
|
|
* Cause the specified action to be performed on a targeted "CPU"
|
|
*/
|
|
|
|
static void msmtc_send_ipi_single(int cpu, unsigned int action)
|
|
{
|
|
/* "CPU" may be TC of same VPE, VPE of same CPU, or different CPU */
|
|
smtc_send_ipi(cpu, LINUX_SMP_IPI, action);
|
|
}
|
|
|
|
static void msmtc_send_ipi_mask(cpumask_t mask, unsigned int action)
|
|
{
|
|
unsigned int i;
|
|
|
|
for_each_cpu_mask(i, mask)
|
|
msmtc_send_ipi_single(i, action);
|
|
}
|
|
|
|
/*
|
|
* Post-config but pre-boot cleanup entry point
|
|
*/
|
|
static void __cpuinit msmtc_init_secondary(void)
|
|
{
|
|
void smtc_init_secondary(void);
|
|
int myvpe;
|
|
|
|
/* Don't enable Malta I/O interrupts (IP2) for secondary VPEs */
|
|
myvpe = read_c0_tcbind() & TCBIND_CURVPE;
|
|
if (myvpe != 0) {
|
|
/* Ideally, this should be done only once per VPE, but... */
|
|
clear_c0_status(ST0_IM);
|
|
set_c0_status((0x100 << cp0_compare_irq)
|
|
| (0x100 << MIPS_CPU_IPI_IRQ));
|
|
if (cp0_perfcount_irq >= 0)
|
|
set_c0_status(0x100 << cp0_perfcount_irq);
|
|
}
|
|
|
|
smtc_init_secondary();
|
|
}
|
|
|
|
/*
|
|
* Platform "CPU" startup hook
|
|
*/
|
|
static void __cpuinit msmtc_boot_secondary(int cpu, struct task_struct *idle)
|
|
{
|
|
smtc_boot_secondary(cpu, idle);
|
|
}
|
|
|
|
/*
|
|
* SMP initialization finalization entry point
|
|
*/
|
|
static void __cpuinit msmtc_smp_finish(void)
|
|
{
|
|
smtc_smp_finish();
|
|
}
|
|
|
|
/*
|
|
* Hook for after all CPUs are online
|
|
*/
|
|
|
|
static void msmtc_cpus_done(void)
|
|
{
|
|
}
|
|
|
|
/*
|
|
* Platform SMP pre-initialization
|
|
*
|
|
* As noted above, we can assume a single CPU for now
|
|
* but it may be multithreaded.
|
|
*/
|
|
|
|
static void __init msmtc_smp_setup(void)
|
|
{
|
|
/*
|
|
* we won't get the definitive value until
|
|
* we've run smtc_prepare_cpus later, but
|
|
* we would appear to need an upper bound now.
|
|
*/
|
|
smp_num_siblings = smtc_build_cpu_map(0);
|
|
}
|
|
|
|
static void __init msmtc_prepare_cpus(unsigned int max_cpus)
|
|
{
|
|
smtc_prepare_cpus(max_cpus);
|
|
}
|
|
|
|
struct plat_smp_ops msmtc_smp_ops = {
|
|
.send_ipi_single = msmtc_send_ipi_single,
|
|
.send_ipi_mask = msmtc_send_ipi_mask,
|
|
.init_secondary = msmtc_init_secondary,
|
|
.smp_finish = msmtc_smp_finish,
|
|
.cpus_done = msmtc_cpus_done,
|
|
.boot_secondary = msmtc_boot_secondary,
|
|
.smp_setup = msmtc_smp_setup,
|
|
.prepare_cpus = msmtc_prepare_cpus,
|
|
};
|
|
|
|
#ifdef CONFIG_MIPS_MT_SMTC_IRQAFF
|
|
/*
|
|
* IRQ affinity hook
|
|
*/
|
|
|
|
|
|
int plat_set_irq_affinity(unsigned int irq, const struct cpumask *affinity)
|
|
{
|
|
cpumask_t tmask;
|
|
int cpu = 0;
|
|
void smtc_set_irq_affinity(unsigned int irq, cpumask_t aff);
|
|
|
|
/*
|
|
* On the legacy Malta development board, all I/O interrupts
|
|
* are routed through the 8259 and combined in a single signal
|
|
* to the CPU daughterboard, and on the CoreFPGA2/3 34K models,
|
|
* that signal is brought to IP2 of both VPEs. To avoid racing
|
|
* concurrent interrupt service events, IP2 is enabled only on
|
|
* one VPE, by convention VPE0. So long as no bits are ever
|
|
* cleared in the affinity mask, there will never be any
|
|
* interrupt forwarding. But as soon as a program or operator
|
|
* sets affinity for one of the related IRQs, we need to make
|
|
* sure that we don't ever try to forward across the VPE boundry,
|
|
* at least not until we engineer a system where the interrupt
|
|
* _ack() or _end() function can somehow know that it corresponds
|
|
* to an interrupt taken on another VPE, and perform the appropriate
|
|
* restoration of Status.IM state using MFTR/MTTR instead of the
|
|
* normal local behavior. We also ensure that no attempt will
|
|
* be made to forward to an offline "CPU".
|
|
*/
|
|
|
|
cpumask_copy(&tmask, affinity);
|
|
for_each_cpu(cpu, affinity) {
|
|
if ((cpu_data[cpu].vpe_id != 0) || !cpu_online(cpu))
|
|
cpu_clear(cpu, tmask);
|
|
}
|
|
cpumask_copy(irq_desc[irq].affinity, &tmask);
|
|
|
|
if (cpus_empty(tmask))
|
|
/*
|
|
* We could restore a default mask here, but the
|
|
* runtime code can anyway deal with the null set
|
|
*/
|
|
printk(KERN_WARNING
|
|
"IRQ affinity leaves no legal CPU for IRQ %d\n", irq);
|
|
|
|
/* Do any generic SMTC IRQ affinity setup */
|
|
smtc_set_irq_affinity(irq, tmask);
|
|
|
|
return 0;
|
|
}
|
|
#endif /* CONFIG_MIPS_MT_SMTC_IRQAFF */
|