kernel-ark/arch/mips/au1000/db1x00/mirage_ts.c
Ralf Baechle 0f04afb595 ISOify.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
2005-10-29 19:30:48 +01:00

262 lines
6.8 KiB
C

/*
* linux/arch/mips/au1000/db1x00/mirage_ts.c
*
* BRIEF MODULE DESCRIPTION
* Glue between Mirage board-specific touchscreen pieces
* and generic Wolfson Codec touchscreen support.
*
* Based on pb1100_ts.c used in Hydrogen II.
*
* Copyright (c) 2003 Embedded Edge, LLC
* dan@embeddededge.com
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the
* Free Software Foundation; either version 2 of the License, or (at your
* option) any later version.
*
* THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
* WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN
* NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
* USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
* ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#include <linux/config.h>
#include <linux/types.h>
#include <linux/module.h>
#include <linux/sched.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/fs.h>
#include <linux/poll.h>
#include <linux/proc_fs.h>
#include <linux/smp.h>
#include <linux/smp_lock.h>
#include <linux/wait.h>
#include <asm/segment.h>
#include <asm/irq.h>
#include <asm/uaccess.h>
#include <asm/delay.h>
#include <asm/au1000.h>
/*
* Imported interface to Wolfson Codec driver.
*/
extern void *wm97xx_ts_get_handle(int which);
extern int wm97xx_ts_ready(void* ts_handle);
extern void wm97xx_ts_set_cal(void* ts_handle, int xscale, int xtrans, int yscale, int ytrans);
extern u16 wm97xx_ts_get_ac97(void* ts_handle, u8 reg);
extern void wm97xx_ts_set_ac97(void* ts_handle, u8 reg, u16 val);
extern int wm97xx_ts_read_data(void* ts_handle, long* x, long* y, long* pressure);
extern void wm97xx_ts_send_data(void* ts_handle, long x, long y, long z);
int wm97xx_comodule_present = 1;
#define TS_NAME "mirage_ts"
#define err(format, arg...) printk(KERN_ERR TS_NAME ": " format "\n" , ## arg)
#define info(format, arg...) printk(KERN_INFO TS_NAME ": " format "\n" , ## arg)
#define warn(format, arg...) printk(KERN_WARNING TS_NAME ": " format "\n" , ## arg)
#define DPRINTK(format, arg...) printk("%s: " format "\n", __FUNCTION__ , ## arg)
#define PEN_DOWN_IRQ AU1000_GPIO_7
static struct task_struct *ts_task = 0;
static DECLARE_COMPLETION(ts_complete);
static DECLARE_WAIT_QUEUE_HEAD(pendown_wait);
#ifdef CONFIG_WM97XX_FIVEWIRETS
static int release_pressure = 1;
#else
static int release_pressure = 50;
#endif
typedef struct {
long x;
long y;
} DOWN_EVENT;
#define SAMPLE_RATE 50 /* samples per second */
#define PEN_DEBOUNCE 5 /* samples for settling - fn of SAMPLE_RATE */
#define PEN_UP_TIMEOUT 10 /* in seconds */
#define PEN_UP_SETTLE 5 /* samples per second */
static struct {
int xscale;
int xtrans;
int yscale;
int ytrans;
} mirage_ts_cal =
{
#if 0
.xscale = 84,
.xtrans = -157,
.yscale = 66,
.ytrans = -150,
#else
.xscale = 84,
.xtrans = -150,
.yscale = 66,
.ytrans = -146,
#endif
};
static void pendown_irq(int irqnr, void *devid, struct pt_regs *regs)
{
//DPRINTK("got one 0x%x", au_readl(SYS_PINSTATERD));
wake_up(&pendown_wait);
}
static int ts_thread(void *id)
{
static int pen_was_down = 0;
static DOWN_EVENT pen_xy;
long x, y, z;
void *ts; /* handle */
struct task_struct *tsk = current;
int timeout = HZ / SAMPLE_RATE;
ts_task = tsk;
daemonize();
tsk->tty = NULL;
tsk->policy = SCHED_FIFO;
tsk->rt_priority = 1;
strcpy(tsk->comm, "touchscreen");
/* only want to receive SIGKILL */
spin_lock_irq(&tsk->sigmask_lock);
siginitsetinv(&tsk->blocked, sigmask(SIGKILL));
recalc_sigpending(tsk);
spin_unlock_irq(&tsk->sigmask_lock);
/* get handle for codec */
ts = wm97xx_ts_get_handle(0);
/* proceed only after everybody is ready */
wait_event_timeout(pendown_wait, wm97xx_ts_ready(ts), HZ/4);
/* board-specific calibration */
wm97xx_ts_set_cal(ts,
mirage_ts_cal.xscale,
mirage_ts_cal.xtrans,
mirage_ts_cal.yscale,
mirage_ts_cal.ytrans);
/* route Wolfson pendown interrupts to our GPIO */
au_sync();
wm97xx_ts_set_ac97(ts, 0x4c, wm97xx_ts_get_ac97(ts, 0x4c) & ~0x0008);
au_sync();
wm97xx_ts_set_ac97(ts, 0x56, wm97xx_ts_get_ac97(ts, 0x56) & ~0x0008);
au_sync();
wm97xx_ts_set_ac97(ts, 0x52, wm97xx_ts_get_ac97(ts, 0x52) | 0x2008);
au_sync();
for (;;) {
interruptible_sleep_on_timeout(&pendown_wait, timeout);
disable_irq(PEN_DOWN_IRQ);
if (signal_pending(tsk)) {
break;
}
/* read codec */
if (!wm97xx_ts_read_data(ts, &x, &y, &z))
z = 0; /* treat no-data and pen-up the same */
if (signal_pending(tsk)) {
break;
}
if (z >= release_pressure) {
y = ~y; /* top to bottom */
if (pen_was_down > 1 /*&& pen_was_down < PEN_DEBOUNCE*/) {//THXXX
/* bounce ? */
x = pen_xy.x;
y = pen_xy.y;
--pen_was_down;
} else if (pen_was_down <= 1) {
pen_xy.x = x;
pen_xy.y = y;
if (pen_was_down)
wm97xx_ts_send_data(ts, x, y, z);
pen_was_down = PEN_DEBOUNCE;
}
//wm97xx_ts_send_data(ts, x, y, z);
timeout = HZ / SAMPLE_RATE;
} else {
if (pen_was_down) {
if (--pen_was_down)
z = release_pressure;
else //THXXX
wm97xx_ts_send_data(ts, pen_xy.x, pen_xy.y, z);
}
/* The pendown signal takes some time to settle after
* reading the pen pressure so wait a little
* before enabling the pen.
*/
if (! pen_was_down) {
// interruptible_sleep_on_timeout(&pendown_wait, HZ / PEN_UP_SETTLE);
timeout = HZ * PEN_UP_TIMEOUT;
}
}
enable_irq(PEN_DOWN_IRQ);
}
enable_irq(PEN_DOWN_IRQ);
ts_task = NULL;
complete(&ts_complete);
return 0;
}
static int __init ts_mirage_init(void)
{
int ret;
/* pen down signal is connected to GPIO 7 */
ret = request_irq(PEN_DOWN_IRQ, pendown_irq, 0, "ts-pendown", NULL);
if (ret) {
err("unable to get pendown irq%d: [%d]", PEN_DOWN_IRQ, ret);
return ret;
}
lock_kernel();
ret = kernel_thread(ts_thread, NULL, CLONE_FS | CLONE_FILES);
if (ret < 0) {
unlock_kernel();
return ret;
}
unlock_kernel();
info("Mirage touchscreen IRQ initialized.");
return 0;
}
static void __exit ts_mirage_exit(void)
{
if (ts_task) {
send_sig(SIGKILL, ts_task, 1);
wait_for_completion(&ts_complete);
}
free_irq(PEN_DOWN_IRQ, NULL);
}
module_init(ts_mirage_init);
module_exit(ts_mirage_exit);