kernel-ark/drivers/net/wireless/orinoco_nortel.c
Pavel Roskin 4c08202547 [PATCH] orinoco: Make nortel_pci_hw_init() static.
Signed-off-by: Pavel Roskin <proski@gnu.org>

Make nortel_pci_hw_init() static.

Found by sparse.
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
2005-09-23 04:36:13 -04:00

309 lines
7.8 KiB
C

/* orinoco_nortel.c
*
* Driver for Prism II devices which would usually be driven by orinoco_cs,
* but are connected to the PCI bus by a Nortel PCI-PCMCIA-Adapter.
*
* Copyright (C) 2002 Tobias Hoffmann
* (C) 2003 Christoph Jungegger <disdos@traum404.de>
*
* Some of this code is borrowed from orinoco_plx.c
* Copyright (C) 2001 Daniel Barlow
* Some of this code is borrowed from orinoco_pci.c
* Copyright (C) 2001 Jean Tourrilhes
* Some of this code is "inspired" by linux-wlan-ng-0.1.10, but nothing
* has been copied from it. linux-wlan-ng-0.1.10 is originally :
* Copyright (C) 1999 AbsoluteValue Systems, Inc. All Rights Reserved.
*
* The contents of this file are subject to the Mozilla Public License
* Version 1.1 (the "License"); you may not use this file except in
* compliance with the License. You may obtain a copy of the License
* at http://www.mozilla.org/MPL/
*
* Software distributed under the License is distributed on an "AS IS"
* basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
* the License for the specific language governing rights and
* limitations under the License.
*
* Alternatively, the contents of this file may be used under the
* terms of the GNU General Public License version 2 (the "GPL"), in
* which case the provisions of the GPL are applicable instead of the
* above. If you wish to allow the use of your version of this file
* only under the terms of the GPL and not to allow others to use your
* version of this file under the MPL, indicate your decision by
* deleting the provisions above and replace them with the notice and
* other provisions required by the GPL. If you do not delete the
* provisions above, a recipient may use your version of this file
* under either the MPL or the GPL.
*/
#define DRIVER_NAME "orinoco_nortel"
#define PFX DRIVER_NAME ": "
#include <linux/config.h>
#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/delay.h>
#include <linux/pci.h>
#include <pcmcia/cisreg.h>
#include "orinoco.h"
#define COR_OFFSET (0xe0) /* COR attribute offset of Prism2 PC card */
#define COR_VALUE (COR_LEVEL_REQ | COR_FUNC_ENA) /* Enable PC card with interrupt in level trigger */
/* Nortel specific data */
struct nortel_pci_card {
unsigned long iobase1;
unsigned long iobase2;
};
/*
* Do a soft reset of the PCI card using the Configuration Option Register
* We need this to get going...
* This is the part of the code that is strongly inspired from wlan-ng
*
* Note bis : Don't try to access HERMES_CMD during the reset phase.
* It just won't work !
*/
static int nortel_pci_cor_reset(struct orinoco_private *priv)
{
struct nortel_pci_card *card = priv->card;
/* Assert the reset until the card notice */
outw_p(8, card->iobase1 + 2);
inw(card->iobase2 + COR_OFFSET);
outw_p(0x80, card->iobase2 + COR_OFFSET);
mdelay(1);
/* Give time for the card to recover from this hard effort */
outw_p(0, card->iobase2 + COR_OFFSET);
outw_p(0, card->iobase2 + COR_OFFSET);
mdelay(1);
/* set COR as usual */
outw_p(COR_VALUE, card->iobase2 + COR_OFFSET);
outw_p(COR_VALUE, card->iobase2 + COR_OFFSET);
mdelay(1);
outw_p(0x228, card->iobase1 + 2);
return 0;
}
static int nortel_pci_hw_init(struct nortel_pci_card *card)
{
int i;
u32 reg;
/* setup bridge */
if (inw(card->iobase1) & 1) {
printk(KERN_ERR PFX "brg1 answer1 wrong\n");
return -EBUSY;
}
outw_p(0x118, card->iobase1 + 2);
outw_p(0x108, card->iobase1 + 2);
mdelay(30);
outw_p(0x8, card->iobase1 + 2);
for (i = 0; i < 30; i++) {
mdelay(30);
if (inw(card->iobase1) & 0x10) {
break;
}
}
if (i == 30) {
printk(KERN_ERR PFX "brg1 timed out\n");
return -EBUSY;
}
if (inw(card->iobase2 + 0xe0) & 1) {
printk(KERN_ERR PFX "brg2 answer1 wrong\n");
return -EBUSY;
}
if (inw(card->iobase2 + 0xe2) & 1) {
printk(KERN_ERR PFX "brg2 answer2 wrong\n");
return -EBUSY;
}
if (inw(card->iobase2 + 0xe4) & 1) {
printk(KERN_ERR PFX "brg2 answer3 wrong\n");
return -EBUSY;
}
/* set the PCMCIA COR-Register */
outw_p(COR_VALUE, card->iobase2 + COR_OFFSET);
mdelay(1);
reg = inw(card->iobase2 + COR_OFFSET);
if (reg != COR_VALUE) {
printk(KERN_ERR PFX "Error setting COR value (reg=%x)\n",
reg);
return -EBUSY;
}
/* set leds */
outw_p(1, card->iobase1 + 10);
return 0;
}
static int nortel_pci_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
int err;
struct orinoco_private *priv;
struct nortel_pci_card *card;
struct net_device *dev;
void __iomem *iomem;
err = pci_enable_device(pdev);
if (err) {
printk(KERN_ERR PFX "Cannot enable PCI device\n");
return err;
}
err = pci_request_regions(pdev, DRIVER_NAME);
if (err != 0) {
printk(KERN_ERR PFX "Cannot obtain PCI resources\n");
goto fail_resources;
}
iomem = pci_iomap(pdev, 3, 0);
if (!iomem) {
err = -ENOMEM;
goto fail_map_io;
}
/* Allocate network device */
dev = alloc_orinocodev(sizeof(*card), nortel_pci_cor_reset);
if (!dev) {
printk(KERN_ERR PFX "Cannot allocate network device\n");
err = -ENOMEM;
goto fail_alloc;
}
priv = netdev_priv(dev);
card = priv->card;
card->iobase1 = pci_resource_start(pdev, 0);
card->iobase2 = pci_resource_start(pdev, 1);
dev->base_addr = pci_resource_start(pdev, 2);
SET_MODULE_OWNER(dev);
SET_NETDEV_DEV(dev, &pdev->dev);
hermes_struct_init(&priv->hw, iomem, HERMES_16BIT_REGSPACING);
printk(KERN_DEBUG PFX "Detected Nortel PCI device at %s irq:%d, "
"io addr:0x%lx\n", pci_name(pdev), pdev->irq, dev->base_addr);
err = request_irq(pdev->irq, orinoco_interrupt, SA_SHIRQ,
dev->name, dev);
if (err) {
printk(KERN_ERR PFX "Cannot allocate IRQ %d\n", pdev->irq);
err = -EBUSY;
goto fail_irq;
}
dev->irq = pdev->irq;
err = nortel_pci_hw_init(card);
if (err) {
printk(KERN_ERR PFX "Hardware initialization failed\n");
goto fail;
}
err = nortel_pci_cor_reset(priv);
if (err) {
printk(KERN_ERR PFX "Initial reset failed\n");
goto fail;
}
err = register_netdev(dev);
if (err) {
printk(KERN_ERR PFX "Cannot register network device\n");
goto fail;
}
pci_set_drvdata(pdev, dev);
return 0;
fail:
free_irq(pdev->irq, dev);
fail_irq:
pci_set_drvdata(pdev, NULL);
free_orinocodev(dev);
fail_alloc:
pci_iounmap(pdev, iomem);
fail_map_io:
pci_release_regions(pdev);
fail_resources:
pci_disable_device(pdev);
return err;
}
static void __devexit nortel_pci_remove_one(struct pci_dev *pdev)
{
struct net_device *dev = pci_get_drvdata(pdev);
struct orinoco_private *priv = netdev_priv(dev);
struct nortel_pci_card *card = priv->card;
/* clear leds */
outw_p(0, card->iobase1 + 10);
unregister_netdev(dev);
free_irq(dev->irq, dev);
pci_set_drvdata(pdev, NULL);
free_orinocodev(dev);
pci_iounmap(pdev, priv->hw.iobase);
pci_release_regions(pdev);
pci_disable_device(pdev);
}
static struct pci_device_id nortel_pci_id_table[] = {
/* Nortel emobility PCI */
{0x126c, 0x8030, PCI_ANY_ID, PCI_ANY_ID,},
{0,},
};
MODULE_DEVICE_TABLE(pci, nortel_pci_id_table);
static struct pci_driver nortel_pci_driver = {
.name = DRIVER_NAME,
.id_table = nortel_pci_id_table,
.probe = nortel_pci_init_one,
.remove = __devexit_p(nortel_pci_remove_one),
};
static char version[] __initdata = DRIVER_NAME " " DRIVER_VERSION
" (Tobias Hoffmann & Christoph Jungegger <disdos@traum404.de>)";
MODULE_AUTHOR("Christoph Jungegger <disdos@traum404.de>");
MODULE_DESCRIPTION
("Driver for wireless LAN cards using the Nortel PCI bridge");
MODULE_LICENSE("Dual MPL/GPL");
static int __init nortel_pci_init(void)
{
printk(KERN_DEBUG "%s\n", version);
return pci_module_init(&nortel_pci_driver);
}
static void __exit nortel_pci_exit(void)
{
pci_unregister_driver(&nortel_pci_driver);
ssleep(1);
}
module_init(nortel_pci_init);
module_exit(nortel_pci_exit);
/*
* Local variables:
* c-indent-level: 8
* c-basic-offset: 8
* tab-width: 8
* End:
*/