kernel-ark/drivers/net/wireless/ath/ath5k/base.h
Bob Copeland 21800491cc ath5k: rework beacon configuration
Using the enable_beacon flag allows some simplifications and fixes
some corner cases in beacon handling.  This change adds a state
variable for beaconing in ath5k_beacon_config and handles both
enabling and disabling, thus eliminating the need for
ath5k_beacon_disable.  We also now configure the beacon when any
of the beacon parameters change, so ath5k_beacon_reconfig is no
longer needed (its mmiowb gets moved to ath5k_beacon_config).
Finally, by locking around the whole config function, we don't
need to worry about clearing the interrupt mask register before
installing the new mask.

The upshot is this correctly disables beaconing when the interfaces
are taken down, it fixes a potential restarting of beaconing
when ath5k_reset() is called, and ensures that updates to the
beacon interval take effect immediately.

Signed-off-by: Bob Copeland <me@bobcopeland.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
2009-07-10 15:02:29 -04:00

202 lines
7.0 KiB
C

/*-
* Copyright (c) 2002-2007 Sam Leffler, Errno Consulting
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer,
* without modification.
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
* similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
* redistribution must be conditioned upon including a substantially
* similar Disclaimer requirement for further binary redistribution.
* 3. Neither the names of the above-listed copyright holders nor the names
* of any contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* Alternatively, this software may be distributed under the terms of the
* GNU General Public License ("GPL") version 2 as published by the Free
* Software Foundation.
*
* NO WARRANTY
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
* AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
* THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
* OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
* IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
* THE POSSIBILITY OF SUCH DAMAGES.
*
*/
/*
* Defintions for the Atheros Wireless LAN controller driver.
*/
#ifndef _DEV_ATH_ATHVAR_H
#define _DEV_ATH_ATHVAR_H
#include <linux/interrupt.h>
#include <linux/list.h>
#include <linux/wireless.h>
#include <linux/if_ether.h>
#include <linux/leds.h>
#include <linux/rfkill.h>
#include "ath5k.h"
#include "debug.h"
#define ATH_RXBUF 40 /* number of RX buffers */
#define ATH_TXBUF 200 /* number of TX buffers */
#define ATH_BCBUF 1 /* number of beacon buffers */
struct ath5k_buf {
struct list_head list;
struct ath5k_desc *desc; /* virtual addr of desc */
dma_addr_t daddr; /* physical addr of desc */
struct sk_buff *skb; /* skbuff for buf */
dma_addr_t skbaddr;/* physical addr of skb data */
};
/*
* Data transmit queue state. One of these exists for each
* hardware transmit queue. Packets sent to us from above
* are assigned to queues based on their priority. Not all
* devices support a complete set of hardware transmit queues.
* For those devices the array sc_ac2q will map multiple
* priorities to fewer hardware queues (typically all to one
* hardware queue).
*/
struct ath5k_txq {
unsigned int qnum; /* hardware q number */
u32 *link; /* link ptr in last TX desc */
struct list_head q; /* transmit queue */
spinlock_t lock; /* lock on q and link */
bool setup;
};
#define ATH5K_LED_MAX_NAME_LEN 31
/*
* State for LED triggers
*/
struct ath5k_led
{
char name[ATH5K_LED_MAX_NAME_LEN + 1]; /* name of the LED in sysfs */
struct ath5k_softc *sc; /* driver state */
struct led_classdev led_dev; /* led classdev */
};
/* Rfkill */
struct ath5k_rfkill {
/* GPIO PIN for rfkill */
u16 gpio;
/* polarity of rfkill GPIO PIN */
bool polarity;
/* RFKILL toggle tasklet */
struct tasklet_struct toggleq;
};
#if CHAN_DEBUG
#define ATH_CHAN_MAX (26+26+26+200+200)
#else
#define ATH_CHAN_MAX (14+14+14+252+20)
#endif
/* Software Carrier, keeps track of the driver state
* associated with an instance of a device */
struct ath5k_softc {
struct pci_dev *pdev; /* for dma mapping */
void __iomem *iobase; /* address of the device */
struct mutex lock; /* dev-level lock */
struct ieee80211_tx_queue_stats tx_stats[AR5K_NUM_TX_QUEUES];
struct ieee80211_low_level_stats ll_stats;
struct ieee80211_hw *hw; /* IEEE 802.11 common */
struct ieee80211_supported_band sbands[IEEE80211_NUM_BANDS];
struct ieee80211_channel channels[ATH_CHAN_MAX];
struct ieee80211_rate rates[IEEE80211_NUM_BANDS][AR5K_MAX_RATES];
s8 rate_idx[IEEE80211_NUM_BANDS][AR5K_MAX_RATES];
enum nl80211_iftype opmode;
struct ath5k_hw *ah; /* Atheros HW */
struct ieee80211_supported_band *curband;
#ifdef CONFIG_ATH5K_DEBUG
struct ath5k_dbg_info debug; /* debug info */
#endif /* CONFIG_ATH5K_DEBUG */
struct ath5k_buf *bufptr; /* allocated buffer ptr */
struct ath5k_desc *desc; /* TX/RX descriptors */
dma_addr_t desc_daddr; /* DMA (physical) address */
size_t desc_len; /* size of TX/RX descriptors */
u16 cachelsz; /* cache line size */
DECLARE_BITMAP(status, 5);
#define ATH_STAT_INVALID 0 /* disable hardware accesses */
#define ATH_STAT_MRRETRY 1 /* multi-rate retry support */
#define ATH_STAT_PROMISC 2
#define ATH_STAT_LEDSOFT 3 /* enable LED gpio status */
#define ATH_STAT_STARTED 4 /* opened & irqs enabled */
unsigned int filter_flags; /* HW flags, AR5K_RX_FILTER_* */
unsigned int curmode; /* current phy mode */
struct ieee80211_channel *curchan; /* current h/w channel */
struct ieee80211_vif *vif;
enum ath5k_int imask; /* interrupt mask copy */
DECLARE_BITMAP(keymap, AR5K_KEYCACHE_SIZE); /* key use bit map */
u8 bssidmask[ETH_ALEN];
unsigned int led_pin, /* GPIO pin for driving LED */
led_on; /* pin setting for LED on */
struct tasklet_struct restq; /* reset tasklet */
unsigned int rxbufsize; /* rx size based on mtu */
struct list_head rxbuf; /* receive buffer */
spinlock_t rxbuflock;
u32 *rxlink; /* link ptr in last RX desc */
struct tasklet_struct rxtq; /* rx intr tasklet */
struct ath5k_led rx_led; /* rx led */
struct list_head txbuf; /* transmit buffer */
spinlock_t txbuflock;
unsigned int txbuf_len; /* buf count in txbuf list */
struct ath5k_txq txqs[AR5K_NUM_TX_QUEUES]; /* tx queues */
struct ath5k_txq *txq; /* main tx queue */
struct tasklet_struct txtq; /* tx intr tasklet */
struct ath5k_led tx_led; /* tx led */
struct ath5k_rfkill rf_kill;
spinlock_t block; /* protects beacon */
struct tasklet_struct beacontq; /* beacon intr tasklet */
struct ath5k_buf *bbuf; /* beacon buffer */
unsigned int bhalq, /* SW q for outgoing beacons */
bmisscount, /* missed beacon transmits */
bintval, /* beacon interval in TU */
bsent;
unsigned int nexttbtt; /* next beacon time in TU */
struct ath5k_txq *cabq; /* content after beacon */
struct timer_list calib_tim; /* calibration timer */
int power_level; /* Requested tx power in dbm */
bool assoc; /* assocate state */
bool enable_beacon; /* true if beacons are on */
};
#define ath5k_hw_hasbssidmask(_ah) \
(ath5k_hw_get_capability(_ah, AR5K_CAP_BSSIDMASK, 0, NULL) == 0)
#define ath5k_hw_hasveol(_ah) \
(ath5k_hw_get_capability(_ah, AR5K_CAP_VEOL, 0, NULL) == 0)
#endif