kernel-ark/arch/sh/include/asm/auxvec.h
Paul Mundt c170f86e31 sh: Make sure AT_SYSINFO_EHDR is exposed to userspace in asm/auxvec.h.
Presently this is protected by a CONFIG_VSYSCALL ifdef so we don't
inadvertently trigger the creation of the gate VMA on CPUs where we don't
enable the vDSO, which is obviously not visible to userspace. Fix this up
by adding in an ifndef __KERNEL__ check at the same time.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>
2008-07-29 23:12:25 +09:00

37 lines
984 B
C

#ifndef __ASM_SH_AUXVEC_H
#define __ASM_SH_AUXVEC_H
/*
* Architecture-neutral AT_ values in 0-17, leave some room
* for more of them.
*/
/*
* This entry gives some information about the FPU initialization
* performed by the kernel.
*/
#define AT_FPUCW 18 /* Used FPU control word. */
#if defined(CONFIG_VSYSCALL) || !defined(__KERNEL__)
/*
* Only define this in the vsyscall case, the entry point to
* the vsyscall page gets placed here. The kernel will attempt
* to build a gate VMA we don't care about otherwise..
*/
#define AT_SYSINFO_EHDR 33
#endif
/*
* More complete cache descriptions than AT_[DIU]CACHEBSIZE. If the
* value is -1, then the cache doesn't exist. Otherwise:
*
* bit 0-3: Cache set-associativity; 0 means fully associative.
* bit 4-7: Log2 of cacheline size.
* bit 8-31: Size of the entire cache >> 8.
*/
#define AT_L1I_CACHESHAPE 34
#define AT_L1D_CACHESHAPE 35
#define AT_L2_CACHESHAPE 36
#endif /* __ASM_SH_AUXVEC_H */