kernel-ark/Documentation/networking/ewrk3.txt
Linus Torvalds 1da177e4c3 Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!
2005-04-16 15:20:36 -07:00

47 lines
2.1 KiB
Plaintext

The EtherWORKS 3 driver in this distribution is designed to work with all
kernels > 1.1.33 (approx) and includes tools in the 'ewrk3tools'
subdirectory to allow set up of the card, similar to the MSDOS
'NICSETUP.EXE' tools provided on the DOS drivers disk (type 'make' in that
subdirectory to make the tools).
The supported cards are DE203, DE204 and DE205. All other cards are NOT
supported - refer to 'depca.c' for running the LANCE based network cards and
'de4x5.c' for the DIGITAL Semiconductor PCI chip based adapters from
Digital.
The ability to load this driver as a loadable module has been included and
used extensively during the driver development (to save those long reboot
sequences). To utilise this ability, you have to do 8 things:
0) have a copy of the loadable modules code installed on your system.
1) copy ewrk3.c from the /linux/drivers/net directory to your favourite
temporary directory.
2) edit the source code near line 1898 to reflect the I/O address and
IRQ you're using.
3) compile ewrk3.c, but include -DMODULE in the command line to ensure
that the correct bits are compiled (see end of source code).
4) if you are wanting to add a new card, goto 5. Otherwise, recompile a
kernel with the ewrk3 configuration turned off and reboot.
5) insmod ewrk3.o
[Alan Cox: Changed this so you can insmod ewrk3.o irq=x io=y]
[Adam Kropelin: Multiple cards now supported by irq=x1,x2 io=y1,y2]
6) run the net startup bits for your new eth?? interface manually
(usually /etc/rc.inet[12] at boot time).
7) enjoy!
Note that autoprobing is not allowed in loadable modules - the system is
already up and running and you're messing with interrupts.
To unload a module, turn off the associated interface
'ifconfig eth?? down' then 'rmmod ewrk3'.
The performance we've achieved so far has been measured through the 'ttcp'
tool at 975kB/s. This measures the total TCP stack performance which
includes the card, so don't expect to get much nearer the 1.25MB/s
theoretical Ethernet rate.
Enjoy!
Dave