kernel-ark/arch/i386/kernel/reboot_fixups.c
Jeremy Fitzhardinge 973efae21b [PATCH] i386: clean up mach_reboot_fixups
The reboot_fixups stuff seems to be a bit of a mess, specifically the
header is in linux/ when its a purely i386-specific piece of code.  I'm
not sure why it has its config option; its only currently needed for
"geode-gx1/cs5530a", so perhaps whatever config option controls that
hardware should enable this?

Signed-off-by: Jeremy Fitzhardinge <jeremy@xensource.com>
Signed-off-by: Andi Kleen <ak@suse.de>
2007-05-02 19:27:06 +02:00

56 lines
1.3 KiB
C

/*
* linux/arch/i386/kernel/reboot_fixups.c
*
* This is a good place to put board specific reboot fixups.
*
* List of supported fixups:
* geode-gx1/cs5530a - Jaya Kumar <jayalk@intworks.biz>
*
*/
#include <asm/delay.h>
#include <linux/pci.h>
#include <asm/reboot_fixups.h>
static void cs5530a_warm_reset(struct pci_dev *dev)
{
/* writing 1 to the reset control register, 0x44 causes the
cs5530a to perform a system warm reset */
pci_write_config_byte(dev, 0x44, 0x1);
udelay(50); /* shouldn't get here but be safe and spin-a-while */
return;
}
struct device_fixup {
unsigned int vendor;
unsigned int device;
void (*reboot_fixup)(struct pci_dev *);
};
static struct device_fixup fixups_table[] = {
{ PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_5530_LEGACY, cs5530a_warm_reset },
};
/*
* we see if any fixup is available for our current hardware. if there
* is a fixup, we call it and we expect to never return from it. if we
* do return, we keep looking and then eventually fall back to the
* standard mach_reboot on return.
*/
void mach_reboot_fixups(void)
{
struct device_fixup *cur;
struct pci_dev *dev;
int i;
for (i=0; i < ARRAY_SIZE(fixups_table); i++) {
cur = &(fixups_table[i]);
dev = pci_get_device(cur->vendor, cur->device, NULL);
if (!dev)
continue;
cur->reboot_fixup(dev);
}
}