kernel-ark/net/wanrouter/Kconfig
Sam Ravnborg 6a2e9b738c [NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.

The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.

Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.

Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
2005-07-11 21:13:56 -07:00

30 lines
1.2 KiB
Plaintext

#
# Configuration for WAN router
#
config WAN_ROUTER
tristate "WAN router"
depends on EXPERIMENTAL
---help---
Wide Area Networks (WANs), such as X.25, frame relay and leased
lines, are used to interconnect Local Area Networks (LANs) over vast
distances with data transfer rates significantly higher than those
achievable with commonly used asynchronous modem connections.
Usually, a quite expensive external device called a `WAN router' is
needed to connect to a WAN.
As an alternative, WAN routing can be built into the Linux kernel.
With relatively inexpensive WAN interface cards available on the
market, a perfectly usable router can be built for less than half
the price of an external router. If you have one of those cards and
wish to use your Linux box as a WAN router, say Y here and also to
the WAN driver for your card, below. You will then need the
wan-tools package which is available from <ftp://ftp.sangoma.com/>.
Read <file:Documentation/networking/wan-router.txt> for more
information.
To compile WAN routing support as a module, choose M here: the
module will be called wanrouter.
If unsure, say N.