kernel-ark/drivers/net/ibm_newemac/Kconfig
David Gibson 1d3bb99648 Device tree aware EMAC driver
Based on BenH's earlier work, this is a new version of the EMAC driver
for the built-in ethernet found on PowerPC 4xx embedded CPUs.  The
same ASIC is also found in the Axon bridge chip.  This new version is
designed to work in the arch/powerpc tree, using the device tree to
probe the device, rather than the old and ugly arch/ppc OCP layer.

This driver is designed to sit alongside the old driver (that lies in
drivers/net/ibm_emac and this one in drivers/net/ibm_newemac).  The
old driver is left in place to support arch/ppc until arch/ppc itself
reaches its final demise (not too long now, with luck).

This driver still has a number of things that could do with cleaning
up, but I think they can be fixed up after merging.  Specifically:
	- Should be adjusted to properly use the dma mapping API.
Axon needs this.
	- Probe logic needs reworking, in conjuction with the general
probing code for of_platform devices.  The dependencies here between
EMAC, MAL, ZMII etc. make this complicated.  At present, it usually
works, because we initialize and register the sub-drivers before the
EMAC driver itself, and (being in driver code) runs after the devices
themselves have been instantiated from the device tree.

Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-10-10 16:51:52 -07:00

64 lines
1.3 KiB
Plaintext

config IBM_NEW_EMAC
tristate "IBM EMAC Ethernet support"
depends on PPC_DCR && PPC_MERGE
help
This driver supports the IBM EMAC family of Ethernet controllers
typically found on 4xx embedded PowerPC chips, but also on the
Axon southbridge for Cell.
config IBM_NEW_EMAC_RXB
int "Number of receive buffers"
depends on IBM_NEW_EMAC
default "128"
config IBM_NEW_EMAC_TXB
int "Number of transmit buffers"
depends on IBM_NEW_EMAC
default "64"
config IBM_NEW_EMAC_POLL_WEIGHT
int "MAL NAPI polling weight"
depends on IBM_NEW_EMAC
default "32"
config IBM_NEW_EMAC_RX_COPY_THRESHOLD
int "RX skb copy threshold (bytes)"
depends on IBM_NEW_EMAC
default "256"
config IBM_NEW_EMAC_RX_SKB_HEADROOM
int "Additional RX skb headroom (bytes)"
depends on IBM_NEW_EMAC
default "0"
help
Additional receive skb headroom. Note, that driver
will always reserve at least 2 bytes to make IP header
aligned, so usually there is no need to add any additional
headroom.
If unsure, set to 0.
config IBM_NEW_EMAC_DEBUG
bool "Debugging"
depends on IBM_NEW_EMAC
default n
# The options below has to be select'ed by the respective
# processor types or platforms
config IBM_NEW_EMAC_ZMII
bool
default n
config IBM_NEW_EMAC_RGMII
bool
default n
config IBM_NEW_EMAC_TAH
bool
default n
config IBM_NEW_EMAC_EMAC4
bool
default n