0e9b4e535f
* limit max PIO mode to PIO4, this driver doesn't support PIO5 and attempt to setup PIO5 by it821x_tuneproc() could result in incorrect PIO timings + incorrect base clock being set for controller in the passthrough mode * move code limiting max PIO according to the pair device capabilities from config_it821x_chipset_for_pio() to it821x_tuneproc() so the check is also applied for mode change requests coming through ->tuneproc and ->speedproc interfaces * set device speed in it821x_tuneproc() * in it821x_tune_chipset() call it821x_tuneproc() also if the controller is in the smart mode (so the check for pair device max PIO is done) * rename it821x_tuneproc() to it821x_tune_pio(), then add it821x_tuneproc() wrapper which does the max PIO mode check; it worked by the pure luck previously, pio[4] and pio_want[4] arrays were used with index == 255 so random PIO timings and base clock were set for the controller in the passthrough mode, thankfully PIO timings and base clock were corrected later by config_it821x_chipset_for_pio() call (but it was not called for PIO-only devices during resume and for user requested PIO autotuning) * remove config_it821x_chipset_for_pio() call from config_chipset_for_dma() as the driver sets ->autotune to 1 and ->tuneproc does the proper job now * convert the last user of config_it821x_chipset_for_pio() to use it821x_tuneproc(drive, 255) and remove no longer needed function While at it: * fix few comments * bump driver version Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com> |
||
|---|---|---|
| .. | ||
| arm | ||
| cris | ||
| h8300 | ||
| legacy | ||
| mips | ||
| pci | ||
| ppc | ||
| ide-acpi.c | ||
| ide-cd.c | ||
| ide-cd.h | ||
| ide-disk.c | ||
| ide-dma.c | ||
| ide-floppy.c | ||
| ide-generic.c | ||
| ide-io.c | ||
| ide-iops.c | ||
| ide-lib.c | ||
| ide-pnp.c | ||
| ide-probe.c | ||
| ide-proc.c | ||
| ide-tape.c | ||
| ide-taskfile.c | ||
| ide-timing.h | ||
| ide.c | ||
| Kconfig | ||
| Makefile | ||
| setup-pci.c | ||