When GSO packets come from an untrusted source (e.g., a Xen guest domain),
we need to verify the header integrity before passing it to the hardware.
Since the first step in GSO is to verify the header, we can reuse that
code by adding a new bit to gso_type: SKB_GSO_DODGY. Packets with this
bit set can only be fed directly to devices with the corresponding bit
NETIF_F_GSO_ROBUST. If the device doesn't have that bit, then the skb
is fed to the GSO engine which will allow the packet to be sent to the
hardware if it passes the header check.
This patch changes the sg flag to a full features flag. The same method
can be used to implement TSO ECN support. We simply have to mark packets
with CWR set with SKB_GSO_ECN so that only hardware with a corresponding
NETIF_F_TSO_ECN can accept them. The GSO engine can either fully segment
the packet, or segment the first MTU and pass the rest to the hardware for
further segmentation.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
When a device that is acting as a bridge port is unregistered, the
ip_queue/nfnetlink_queue notifier doesn't check if its one of
physindev/physoutdev and doesn't release the references if it is.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
xt_sctp uses an incorrect header offset when --chunk-types is used.
Signed-off-by: Jorge Matias <jorge.matias@motorola.com>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
"xt_unregister_match(AF_INET, &tcp_matchstruct)" is called twice,
leaving "udp_matchstruct" registered, in case of a failure in the
registration of the udp6 structure.
Signed-off-by: Yuri Gushin <yuri@ecl-labs.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
CC net/netfilter/nf_conntrack_proto_sctp.o
net/netfilter/nf_conntrack_proto_sctp.c: In function `sctp_print_conntrack':
net/netfilter/nf_conntrack_proto_sctp.c:206: warning: implicit declaration of function `local_bh_disable'
net/netfilter/nf_conntrack_proto_sctp.c:208: warning: implicit declaration of function `local_bh_enable'
CC net/netfilter/nf_conntrack_netlink.o
net/netfilter/nf_conntrack_netlink.c: In function `ctnetlink_dump_table':
net/netfilter/nf_conntrack_netlink.c:429: warning: implicit declaration of function `local_bh_disable'
net/netfilter/nf_conntrack_netlink.c:452: warning: implicit declaration of function `local_bh_enable'
Spotted by Toralf Förster
Signed-off-by: Yasuyuki Kozakai <yasuyuki.kozakai@toshiba.co.jp>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
When xt_register_table fails the error is not properly propagated back.
Based on patch by Lepton Wu <ytht.net@gmail.com>.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
1) Need to unregister 2 ports per of_device.
2) Need to of_iounmap() 1 mapping per of_device.
3) Need to free up the IRQ only after all devices
have been unregistered.
Signed-off-by: David S. Miller <davem@davemloft.net>
Happily, life is much simpler on 32-bit sparc systems.
The "intr" property, preferred over the "interrupts"
property is used-as. Some minor translations of this
value happen on sun4d systems.
The stage is now set to rewrite the sparc serial driver
probing to use the of_driver framework, and then to convert
all SBUS, EBUS, and ISA drivers in-kind so that we can nuke
all those special bus frameworks.
Signed-off-by: David S. Miller <davem@davemloft.net>
Do IRQ determination generically by parsing the PROM properties,
and using IRQ controller drivers for final resolution.
One immediate positive effect is that all of the IRQ frobbing
in the EBUS, ISA, and PCI controller layers has been eliminated.
We just look up the of_device and use the properly computed
value.
The PCI controller irq_build() routines are gone and no longer
used. Unfortunately sbus_build_irq() has to remain as there is
a direct reference to this in the sunzilog driver. That can be
killed off once the sparc32 side of this is written and the
sunzilog driver is transformed into an "of" bus driver.
Signed-off-by: David S. Miller <davem@davemloft.net>
This needs to be a unique interrupt source because we do
not have a register or similar to poll to make sure the
IRQ is really for us. We do not have any dev_id to pass
in anyways, and the generic IRQ layer is now enforcing
that when SA_SHIRQ is specified, dev_id must be non-NULL.
Signed-off-by: David S. Miller <davem@davemloft.net>
On sparc64 we don't need to do this because the resource
values are large enough to encode the full physical address.
Signed-off-by: David S. Miller <davem@davemloft.net>
The idea is to fully construct the device register and
interrupt values into these of_device objects, and convert
all of SBUS, EBUS, ISA drivers to use this new stuff.
Much ideas and code taken from Ben H.'s powerpc work.
Signed-off-by: David S. Miller <davem@davemloft.net>
Totally unused.
We need to traverse the list of global IRQ translaters,
so storing it in the per-bus structures was useless.
Signed-off-by: David S. Miller <davem@davemloft.net>
Get rid of osb->uuid, osb->proc_sub_dir, and osb->osb_id. Those fields were
unused, or could easily be removed. As a result, we also no longer need
MAX_OSB_ID or ocfs2_globals_lock.
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
dlm_lockres_master_requery() became global without any external usage.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
Give gcc the chance to compile out the debug logging code in ocfs2.
This saves some size at the expense of being able to debug the code.
Signed-off-by: Joel Becker <joel.becker@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
The configfs_example module was missing a ->release().
Signed-off-by: Joel Becker <joel.becker@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
