kernel-ark/arch/powerpc/xmon/Makefile

# Makefile for xmon

ifdef CONFIG_PPC64
EXTRA_CFLAGS += -mno-minimal-toc
endif

obj-y			+= xmon.o setjmp.o start.o nonstdio.o

ifdef CONFIG_XMON_DISASSEMBLY
obj-y			+= ppc-dis.o ppc-opc.o
obj-$(CONFIG_PPC_CELL)	+= spu-dis.o spu-opc.o
endif
powerpc: Merge xmon The merged version follows the ppc64 version pretty closely mostly, and in fact ARCH=ppc64 now uses the arch/powerpc/xmon version. The main difference for ppc64 is that the 'p' command to call show_state (which was always pretty dodgy) has been replaced by the ppc32 'p' command, which calls a given procedure (so in fact the old 'p' command behaviour can be achieved with 'p $show_state'). Signed-off-by: Paul Mackerras <paulus@samba.org> 2005-10-28 12:53:37 +00:00			`# Makefile for xmon`

			`ifdef CONFIG_PPC64`
			`EXTRA_CFLAGS += -mno-minimal-toc`
			`endif`
[POWERPC] Make xmon disassembly optional While adding spu disassembly support it struck me that we're actually carrying quite a lot of code around, just to do disassembly in the case of a crash. While on large systems it's not an issue, on smaller ones it might be nice to have xmon - but without the weight of the disassembly support. For a Cell build this saves ~230KB (!), and for pSeries ~195KB. We still support the 'di' and 'sdi' commands, however they just dump the instruction in hex. Move the definitions into a header to clean xmon.c just a tiny bit. Signed-off-by: Michael Ellerman <michael@ellerman.id.au> Signed-off-by: Arnd Bergmann <arnd.bergmann@de.ibm.com> 2006-11-22 23:46:45 +00:00
			`obj-y += xmon.o setjmp.o start.o nonstdio.o`

			`ifdef CONFIG_XMON_DISASSEMBLY`
			`obj-y += ppc-dis.o ppc-opc.o`
[POWERPC] Add spu disassembly to xmon This patch adds a "sdi" command to xmon, to disassemble the contents of an spu's local store. Signed-off-by: Michael Ellerman <michael@ellerman.id.au> Signed-off-by: Arnd Bergmann <arnd.bergmann@de.ibm.com> 2006-11-22 23:46:44 +00:00			`obj-$(CONFIG_PPC_CELL) += spu-dis.o spu-opc.o`
[POWERPC] Make xmon disassembly optional While adding spu disassembly support it struck me that we're actually carrying quite a lot of code around, just to do disassembly in the case of a crash. While on large systems it's not an issue, on smaller ones it might be nice to have xmon - but without the weight of the disassembly support. For a Cell build this saves ~230KB (!), and for pSeries ~195KB. We still support the 'di' and 'sdi' commands, however they just dump the instruction in hex. Move the definitions into a header to clean xmon.c just a tiny bit. Signed-off-by: Michael Ellerman <michael@ellerman.id.au> Signed-off-by: Arnd Bergmann <arnd.bergmann@de.ibm.com> 2006-11-22 23:46:45 +00:00			`endif`